IA-2 QUESTION BANK

SIGNALS AND SYSTEMS (241EC014)

UNIT-III
CO3 Compute the Laplace transform of the following and plot its ROC
− at
i) x(t) = Cos 3t ii) x(t) = t sin at iii) x(t)=e-at u(t), a>0 iv) x(t ) = −e u (−t ) a>0
State and explain the properties of Laplace transform
State and explain the properties of Z-transform
Find the z transform of the following signals and plot its ROC
i) x[n] = u[n] - u[n-4] ii) x[n] = an u[n] iii) x[n] = − a u[− n − 1] iv) x[n] = an u[n] −b u[−n − 1]
n n

UNIT-IV
CO4 Compute the convolution between i) e-2t u (t) and u (t) ii) u(t) and u(t) iii) e-at u(t) and e-bt u(t)
State and prove the properties of convolution.
State and prove sampling theorem for band limited signals
Find the sampling rate and sampling interval of the following signals.
i) x(t)= 2cos 100 πt ii) x(t)=sinc(200t) +sinc2(200t) iii) x(t)=cos (100 πt)*cos(200 πt)

UNIT-V
CO5 Verify whether the given system is static, causal, linear and time invariant or not.
i) y(t)=x(2t) ii) y(t)=tx(t) iii) y (t ) = log10 x(t )
Discuss about distortion less transmission through a system.
Explain the filter characteristics of ideal LPF, HPF using their magnitude and phase responses.
Obtain the impulse response of an LTI system defined by dy(t)/dt + 2y(t) = x(t). Also obtain the response of
this system when excited by e-2t u(t).

*****

Answers
UNIT-III
1. Compute the Laplace transform of the following
and plot its ROC
i) x(t) = Cos 3t
ii) x(t) = t sin at
iii) x(t)=e-at u(t), a>0
iv) x(t ) = −e a>0
− at
u (−t )
State and explain the properties of Laplace
transform
State and explain the properties of Z-transform
Find the z transform of the following signals and plot
its ROC

i) x[n] = u[n] - u[n-4]

ii) x[n] = an u[n]
iii) x[n] = − a nu[− n − 1]
 x[n] = an u[n] −b u[−n − 1]
n
iii)
 UNIT-IV
Compute the convolution between
i) e-2t u (t) and u (t)

ii) u(t) and u(t)

iv) e-at u(t) and e-bt u(t)
State and prove the properties of convolution.
State and prove sampling theorem for band limited
signals
Any Band limited signal is sampled and the original signal can be reconstructed from its
samples only when sampling frequency is greater than or equal to twice the maximum
frequency of the band pass signal.
𝑓𝑠 ≥ 2𝑓𝑚
Find the sampling rate and sampling interval of the
following signals

i) x(t)= 2cos 100 πt

ii) x(t)=sinc(200t) +sinc2(200t)
iii) x(t)=cos (100 πt)*cos(200 πt)
i) ii) iii) y (t ) = log10 x(t )

Verify whether the given system is static, causal,

linear and time invariant or not.
i) y(t)=x(2t)
ii) y(t)=tx(t)
iii) y (t ) = log10 x(t )
Discuss about distortion less transmission through a
system.
Explain the filter characteristics of ideal LPF, HPF
using their magnitude and phase responses
Obtain the impulse response of an LTI system defined
by dy(t)/dt + 2y(t) = x(t). Also obtain the response of
this system when excited by e-2t u(t).
 Prepared By
A. Kondababu,
Assistant professor,
ECE Department,
Aditya University,
Surampalem.