GB/T 9754-2007 (English Version) Paints and varnishes—Determination of specular gloss of non-metallic paint films at 20° 60°and 85°
Uploaded by
coolfireGB/T 9754-2007 (English Version) Paints and varnishes—Determination of specular gloss of non-metallic paint films at 20° 60°and 85°
Uploaded by
coolfirehttps://www.ChinaStandard.
net -> Buy the full version PDF
ICS 87.040
G 50
National Standard of the People’s Republic of China
GB/T 9754-2007/ISO 2813:1994
Replaces GB/T 9754-1988
Paints and Varnishes — Determination of
Specular Gloss of Non-metallic Paint
Films at 20°, 60°and 85°
色漆和清漆 不含金属颜料的色漆漆膜的 20°、60°和 85°镜面光
泽的测定
(ISO 2813:1994, IDT)
(English Translation)
Issue date: 2007-09-11 Implementation date: 2008-04-01
Issued by the General Administration of Quality Supervision,
Inspection and Quarantine of the People's Republic of China
the Standardization Administration of the People's Republic
of China
https://www.chinastandard.net/i/GBT9754-2007.html
https://www.ChinaStandard.net -> Buy the full version PDF
Contents
Foreword ........................................................................................................................... II
1 Scope .......................................................................................................................... 1
2 Normative References ................................................................................................. 1
3 Terms and Definitions .................................................................................................. 2
4 Required Supplementary Information .......................................................................... 2
5 Apparatus .................................................................................................................... 2
6 Sampling of Liquid Paints ............................................................................................ 7
7 Sampling of Coated Substrates ................................................................................... 7
8 Preparation of Test Panels .......................................................................................... 8
9 Calibration of the Glossmeter ...................................................................................... 9
10 Procedure .................................................................................................................. 9
11 Precision (Applicable to Films on Glass Plates Only) .............................................. 10
12 Test Report .............................................................................................................. 10
Annex A (Normative) Required Supplementary Information ......................................... 12
Annex B (Informative) Bibliography .............................................................................. 13
https://www.chinastandard.net/i/GBT9754-2007.html
https://www.ChinaStandard.net -> Buy the full version PDF
Paints and Varnishes — Determination of
Specular Gloss of Non-metallic Paint Films at
20°, 60°and 85°
1 Scope
1.1 This standard is one of a series of standards dealing with the sampling and testing of
paints, varnishes and related products.
It specifies a test method for determining the specular gloss of paint films using a
reflectometer geometry of 20°, 60° or 85°. The method is not applicable to the
measurement of the gloss of metallic paints.
a) The 60°geometry is applicable to all paint films, but for very high gloss and near-matt
films 20°or 85°may be more suitable.
b) The 20° geometry, which uses a smaller receptor aperture, is intended to give
improved differentiation between high-gloss paint films (i.e. films with a 60°specular
gloss higher than about 70 units).
c) The 85° geometry is intended to give improved differentiation between low-gloss
paint films (i.e. films with a 60°specular gloss lower than about 10 units).
Note 1: The same geometry should, of course, be retained for a series of measurements even if this
means disregarding the suggested limits.
Note 2: In some cases, the determination of specular gloss may not correspond to a visual assessment.
2 Normative References
The following normative document contains provisions which, through reference in this
text, constitute provisions of this standard. For dated references, subsequent
amendments to, or revisions of, any of these publications do not apply. However, parties
to agreements based on this standard are encouraged to investigate the possibility of
applying the most recent edition of the normative document indicated below. For undated
references, the latest edition of the normative document referred to applies.
GB/T 3186-2006 Paints, Varnishes and Raw Materials for Paints and Varnishes —
Sampling (ISO 15528:2000, IDT)
GB/T 13452.2 Paints and Varnishes — Determination of Film Thickness (GB/T
13452.2-1992, eqv ISO 2808:1974)
https://www.chinastandard.net/i/GBT9754-2007.html
https://www.ChinaStandard.net -> Buy the full version PDF
Annex B
(Informative)
Bibliography
The following standard contains useful information about the determination of the specular
gloss of materials other than non-metallic paint films.
[1] ISO 7668:1986 Anodized Aluminium and Aluminium Alloys — Measurement of
Specular Reflectance and Specular Gloss at Angles of 20 Degrees, 45 Degrees, 60
Degrees or 85 Degrees.
13
https://www.chinastandard.net/i/GBT9754-2007.html
