Code No: R203204J R20 SET -1

III B. Tech II Semester Supplementary Examinations, December -2023

FUNDAMENTALS OF MICROPROCESSORS AND MICROCONTROLLERS
(Com to CSE,IT,CS,CSE(CS),CSE(AI),CSE(DS),CSE(IOT))
Time: 3 hours Max. Marks: 70
Answer any FIVE Questions ONE Question from Each unit
All Questions Carry Equal Marks
*****
UNIT-I
1. a) Give the difference between minimum mode and maximum mode of operation in [7M]
8086 microprocessor.
b) Briefly explain register organization in 8086 microprocessor. [7M]
(OR)
2. a) Define interrupt, Give the difference between maskable and non-maskable interrupt. [7M]
b) Draw and explain 8086 timing diagram during write operation. [7M]

ES
UNIT-II
3. a) Develop an assembly language program to find the sum of numbers from 1 to 100. [7M]

AT
b) Explain the following instructions of 8086: i) AAM ii) DAS iii) LOCK iv) CALL. [7M]
(OR)
4. PD
a) List out assembler directives of 8086 and explain them briefly.
b) Write an ALP in 8086 to exchange a block of N bytes of data between source and
[7M]
[7M]
destination.
TU

UNIT-III
5. a) With a neat block diagram, explain in detail the internal architecture of 8255 and its [7M]
registers.
S

b) Draw the block diagram of 8251 and explain about each block. [7M]
FA

(OR)
6. a) Write the mode control word for a case of asynchronous transmission, with an 8-bit [7M]
data format, one stop bit, odd parity and 10000 baud rate. TxC clock is 150 KHz.
TU

b) Differentiate 8251 and 8255 processors. [7M]

UNIT-IV
7. a) Draw and explain the internal architecture of 8051 microcontroller. [7M]
JN

b) Write an assembly language program using 8051 microcontroller instructions to [7M]

generate a square wave at port 1, pin 0 (i.e., P 1.0). The frequency of the generated
square wave is to be 1 kHz.
(OR)
8. a) Explain the different assembly programming tools used in 8051 microcontroller in [7M]
detail.
b) Explain the Memory organization of 8051. [7M]
UNIT-V
9. a) Explain the application “key board and display interface” of controller [7M]
b) Write a simple program to control (Toggle) the LED Array connected at [7M]
PORTB using byte option.
(OR)
10. a) Explain the application “servo motor Control” of controller [7M]
b) Write A simple program to demonstrate Seven Segment Display. [7M]

1 of 1

|'''|'|'|''|''||'|||