Contents
Topics Slide Number
Objectives 3
Introduction 4
Block Diagram 5-6
Hardware Model 7-8
Result 9-10
Conclusion 11
Future Scope 12
References 13
1
Objectives
To get the control of home appliances using INFRARED REMOTE SWITCH USING
MICROCONTROLLER.
To switch on/off the Home Appliances by using a standard Remote control.
The system can be used to switch on/off upto six electrical devices.
The project can switch on/off electrical devices of maximum load current of 5Amperes.
2
Introduction
In this project we are operating different types of devices from a certain distance by a
RC5 remote.
Microcontroller (AT89C2051) and inverter is used.
A 12v supply is taken parallel and fed to relay driver ic (ULN2003) which require for the
relay to operate.
The IR receiver and crystal oscillator are connected to the microcontroller and the relay
are connected to IC ULN2003.
3
Block Diagram
4
Hardware Model
5
The Burning Of AT89C2051 Microcontroller.
6
RESULTS:
Fig 1. Load Used 7
Fig 2. working model of the project 8
Conclusion
A remote controlled device primarily saves a lot of time and energy..
It can be used in the case of a number of devices and applications such as TV, VCR,
camera, CD speller, radio, lamp, fan, music system.
The remote control can extend up to a long distance depending on the frequency used
and the efficiency of the circuit.
A single remote control can be made to operate at different frequencies, each
corresponding to a particular task to be performed by the appliance,
Tediousness of operating the appliance in its close proximity is done away with.
9
Future Scope
The range of the remote control IR sensor is upto 10 meters. Further improvement can be
done to increase the range.
High power devices can be connected through this system after using further work on
relay.
A further improvement can be done increasing the number of devices connected more
than 6) by using different microcontroller using different code.
Load capacity more than 5 A can be connected after further research work.
10
References
[1] C.S.Choy, "An Infra-red Remote Control System Designed for Universal Control," IEEE
Trans. on Consumer Electronics, Vol.41, No.4, pp. 1089-1094, Nov. 1995.
[2] K. Mandai, K. Miyauchi, M. Sugimoto, et al. "An advanced infrared remote control
sensor". IEEE Transactions on Consumer Electronics, Aug, 1990, Vol. 36, No. 3: 669-677
[3] Li Qiong, Xu Haifeng, Liu Xiande, et al. "Analysis of communication protocol in the
infrared control system of intelligent home". Control and Automation, 2007, Vol.23, No.
1.1:28-30
[4] A. ROGALSKI, K. CHRZANOWSKI. Infrared devices and techniques [J]. OPTO-
ELECTRONICS REVIEW10, 2002(2): 111-136.
[5] Infrared Receiver Module Handbook. Unity Opto Technology Corporation, 2000
11
