Scribd
Upload
136 views

Automatic Cell Planning

Optimiasi physical tuning antena sektoral jaringan LTE dengan menggunakan metode Automatic Cell Planning (ACP)

Uploaded by

Afatah Purnama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
136 views

Automatic Cell Planning

Optimiasi physical tuning antena sektoral jaringan LTE dengan menggunakan metode Automatic Cell Planning (ACP)

Uploaded by

Afatah Purnama
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 12

“OPTIMIZATION OF PHYSICAL TUNING SECTORAL ANTENA LTE

NETWORKS BY USING THE METHOD OF AUTOMATIC CELL


PLANNING (ACP) IN PURWOKERTO CITY”
Afatah Purnama
16201036
Supervisor :
1. Eka Setia Nugraha, S.T., M.T
2. Muntaqo Alfin Amanaf, S.ST., M.T
BACKGROUND
FORMULATION OF THE PROBLEM

1. How to obtain network optimization results on coverage area through physical tuning
antenna using the Automatic Cell Planning (ACP) method with Atoll simulation?
2. How to get the network simulation results on coverage area based on data obtained
from the existing site of Purwokerto city?
3. What is the result of the comparison of the value network optimization to coverage
area between the acquisition of existing site data with the Automatic Cell Planning
(ACP) method?
SCOPE OF THE PROBLEM

1. Used data site existing Purwokerto


2. Optimization is based on coverage of eNodeB using Atoll software simulation
3. Used frequency LTE 1800 MHz
4. Network optimization used the method of Automatic Cell Planning (ACP)
5. The parameter that observed is RSRP and CINR
6. Comparing of simulation results between the existing site data and with the Automatic
Cell Planning (ACP) method
7. Atoll simulation based on existing antenna parameters used by Operator X
FLOWCHART
Location Existing Site Data
Start Study Of Literature
Determination Collection

No

Target
Automatic Cell Coverage Prediction
-95 dBm RSRP -80 dBm =
Planning (ACP) Site Existing
80%
Optimization Simulation
0 CINR 10 = 50 %

Yes

Comparison of
Finish
Simulation Results
DOWNLINK LINK BUDGET
Transmitter - eNodeB Unit Value Calculation

Tx Power dBm 46 a
Tx Antena Gain dBi 18 b
Cable Loss dB 2 c
EIRP dBm 62 d=a+b–c
Receiver - UE
UE Noise Figure dB 7 e
Thermal Noise dB -173,84 f = k*T
SINR dB 11 g
Bandwidth System dB 71,3033 h = 15*12*75*1000
Receiver Sensitifity dBm -84,541 i=e+f+g+h
Interference Margin dB 4 j
Rx Antena Gain dBi 0 k
Body Loss dB 0 l
MAPL dB 142,541 m=d–i–j–k+l
SITE EXISTING DATA ON ATOLL

Region Description
West Purwokerto = 740 ha
East Purwokerto = 842 ha
Total Area = 1582 ha

Cell
27 Sites
105 Sectors

Main Propagation Model


Cost Hatta

Frequency
1800 Mhz
Bandwidth = 15 MHz
Duplexing Method = FDD
SIMULATION WITH ACP METHOD
HISTOGRAM PARAMETER OF SITE EXISTING
1. Reference Signal Received Power 2. Carrier to Interference Noise Ratio
(RSRP) (CINR)
HISTOGRAM PARAMETER OF ACP METHOD
1. Reference Signal Received Power 2. Carrier to Interference Noise Ratio
(RSRP) (CINR)
CONCLUSION

1. The results of RSRP values site existing simulation on range -95 dBm ≤ -80 dBm
is 68,94% and CINR on range 0 dB ≤ 10 dB is 43,1%
2. The results of RSRP values with ACP method simulation on range -95 dBm ≤ -80 dBm
is 80,20% and CINR on range 0 dB ≤ 10 dB is 59%
3. The optimization results using the ACP method experienced an increase in the
percentage on the RSRP is 11,26% and on the CINR is 15,9%
Thank you
Any Questions?

You might also like