Scribd
Upload
130 views1 page

Summary of High Cap Parameters

The document summarizes high capacity parameters for a network. It lists current parameter values and recommended values to maximize resources, increase throughput, and reduce signaling load. The recommended values include increasing the number of supported SR and CQI users, adjusting scheduling algorithms, increasing inactivity timers, and adjusting RLC configuration parameters and thresholds.

Uploaded by

Asmae
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
130 views1 page

Summary of High Cap Parameters

The document summarizes high capacity parameters for a network. It lists current parameter values and recommended values to maximize resources, increase throughput, and reduce signaling load. The recommended values include increasing the number of supported SR and CQI users, adjusting scheduling algorithms, increasing inactivity timers, and adjusting RLC configuration parameters and thresholds.

Uploaded by

Asmae
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Summary of high cap parameters

Parameter Current Recommended Objective

noOfPucchSrUsers 320 640 Maximize number of allowed SR users

noOfPucchCqiUsers 320 640 Maximize number of allowed CQI users

pdcchCfiMode (10MHz) CFI_AUTO_MAXIMUM_ CFI_AUTO_MAXIMUM_3 (no Recommended setting is already set, just monitor CCE
3 change) and CFI usage
pZeroNominalPucch -117 -117 (no change) Recommended setting is already set

pZeroNominalPusch -96 -103 Reduce UL noise rise at high load

schedulingAlgorithm 3 4 (PROPORTIONAL_FAIR_LOW) Increase cell throughput and PRB utilization


(PROPORTIONAL_FAIR_ or 5 (MAXIMUM_C_OVER_I)
MEDIUM)
tInactivityTimer 10s 30s Reduce signaling load

SRB/DRB::dlMaxRetxThreshold 8/8 8/8 (no change) Max # RLC re-Tx in UL/DL (control signaling load).
SRB/DRB::ulMaxRetxThreshold 8/8 8/8 (no change) Recommended setting is already set
SRB/DRB::tPollRetransmitDl 45ms/50ms 80ms/80ms Increase poll timer for RLC re-Tx (if no status report
SRB/DRB::tPollRetransmitUl 45ms/50ms 80ms/80ms received) to avoid RLC failures, reduce signaling load
T310 / T311 20 / 1 20 / 1 (no change) Recommended setting is already set, for RLC
supervision
N310 / N311 2s / 3s 2s / 3s (no change) Recommended setting is already set, for RLC
supervision
a3Offset 30 (3dB) 50 (5dB) (low priority) Reduce signaling load. Will review feasibility to use
alternative approach on ‘UE Level Oscillating Handover
Minimization’ feature

You might also like