Scribd
Upload
15K views11 pages

Smaw NC I Reviewer: Oral Questioning

The document discusses questions and answers related to shielded metal arc welding (SMAW). It addresses how wind velocity can cause porosity in welds, how to avoid defects like porosity and slag inclusions by cleaning the workpiece, defines root pass, filling pass and capping, and how to prevent injuries and electric shock during welding by using proper protective equipment. It also covers how to avoid undercut and burn-through by selecting a lower amperage, what causes warping or distortion, and how using a wet electrode can cause porosity or cracks in the weld.

Uploaded by

OFFSHORE-ONSHORE INSTITUTE OF TECHNOLOGY INC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
15K views11 pages

Smaw NC I Reviewer: Oral Questioning

The document discusses questions and answers related to shielded metal arc welding (SMAW). It addresses how wind velocity can cause porosity in welds, how to avoid defects like porosity and slag inclusions by cleaning the workpiece, defines root pass, filling pass and capping, and how to prevent injuries and electric shock during welding by using proper protective equipment. It also covers how to avoid undercut and burn-through by selecting a lower amperage, what causes warping or distortion, and how using a wet electrode can cause porosity or cracks in the weld.

Uploaded by

OFFSHORE-ONSHORE INSTITUTE OF TECHNOLOGY INC
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 11

SMAW NC I REVIEWER

ORAL QUESTIONING
What is the effect of wind velocity on
the weld?

POROSITY
How can we avoid porosity or slag
in the weld?
Always clean the
workpiece
What is rootpass? filling pass?
capping?

root pass- first weld in a joint


filling pass- filling up the weld grove
capping- final cover
How do can we avoid undercut and
burn-through?

to avoid burn-through and undercut -


select lower amperage
How can we prevent weld related
injuries?

Use proper PPE (Personal


Protective Equipment)
How can we avoid Electric Shock during
welding?

- use PPE
- Always check the electrode holder
cable and ground cable
What causes warpage or distortion?

- excessive heat input


- high amperage
How can we prevent slag inclusion
and undercut?

Always clean the workpiece


What is the effect of using wet electrode on
the weld?

It can cause crack on the weld but most


probable effect is the occurrence of
porosities or small holes on the weld.
GOOD LUCK
EVERYONE!!!!

You might also like