Scribd
Upload
28 views

Chapter 2 - Network Model - Part B

Uploaded by

Golam Muktadir
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
28 views

Chapter 2 - Network Model - Part B

Uploaded by

Golam Muktadir
Copyright
© © All Rights Reserved
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 16

Chapter 2

Network Models
PART B

2.1 Copyright © The McGraw-Hill Companies, Inc. Permission required for reproduction or display.
2-4 TCP/IP PROTOCOL SUITE

The layers in the TCP/IP protocol suite do not exactly


match those in the OSI model. The original TCP/IP
protocol suite was defined as having four layers: host-to-
network, internet, transport, and application. However,
when TCP/IP is compared to OSI, we can say that the
TCP/IP protocol suite is made of five layers: physical,
data link, network, transport, and application.

Topics discussed in this section:


Physical and Data Link Layers
Network Layer
Transport Layer
Application Layer
2.2
Figure 2.16 TCP/IP and OSI model

SMTP FTP SNMP

2.3
2-5 ADDRESSING

Four levels of addresses are used in an internet employing


the TCP/IP protocols: physical, logical, port, and specific.

Topics discussed in this section:


Physical Addresses
Logical Addresses
Port Addresses
Specific Addresses

2.4
Figure 2.17 Addresses in TCP/IP

2.5
Figure 2.18 Relationship of layers and addresses in TCP/IP

2.6
Example 2.1

In Figure 2.19 a node with physical address 10 sends a


frame to a node with physical address 87. The two nodes
are connected by a link (bus topology LAN). As the
figure shows, the computer with physical address 10 is
the sender, and the computer with physical address 87 is
the receiver.

2.7
Figure 2.19 Physical addresses

2.8
Example 2.2

As we will see in Chapter 13, most local-area networks


use a 48-bit (6-byte) physical address written as 12
hexadecimal digits; every byte (2 hexadecimal digits) is
separated by a colon, as shown below:

07:01:02:01:2C:4B

A 6-byte (12 hexadecimal digits) physical address.

2.9
Example 2.3

Figure 2.20 shows a part of an internet with two routers


connecting three LANs. Each device (computer or
router) has a pair of addresses (logical and physical) for
each connection. In this case, each computer is
connected to only one link and therefore has only one
pair of addresses. Each router, however, is connected to
three networks (only two are shown in the figure). So
each router has three pairs of addresses, one for each
connection.

2.10
Figure 2.20 IP addresses

2.11
Example 2.4

Figure 2.21 shows two computers communicating via the


Internet. The sending computer is running three
processes at this time with port addresses a, b, and c. The
receiving computer is running two processes at this time
with port addresses j and k. Process a in the sending
computer needs to communicate with process j in the
receiving computer. Note that although physical
addresses change from hop to hop, logical and port
addresses remain the same from the source to
destination.

2.12
Figure 2.21 Port addresses

2.13
Note

The physical addresses will change from hop to hop,


but the logical addresses usually remain the same.

2.14
Example 2.5

As we will see in Chapter 23, a port address is a 16-bit


address represented by one decimal number as shown.

753

A 16-bit port address represented


as one single number.

2.15
Note

The physical addresses change from hop to hop,


but the logical and port addresses usually remain the same.

2.16

You might also like