Feedback amplifiers
Download as PPT, PDF61 likes67,784 views
This document discusses negative feedback in amplifiers. It defines feedback as part of the output signal being returned to the input. Negative feedback occurs when the feedback signal is out of phase with the input signal. There are four types of feedback classified by the sampling and mixing networks: voltage series, current series, current shunt, and voltage shunt. Negative feedback provides advantages like stabilized gain and operating point but results in reduced gain. It has applications in electronic amplifiers, regulated power supplies, and wideband amplifiers.
Feedback amplifiers
- 1. UIT RGPV PROJECT FOR BE SUBMITTED TO SUBMITTED BY PROF.RITESH AGRAWAL KALPANA VERMA BRANCH:- IT 3 rd SEM ROLL.NO. 0101IT101033
- 2. Feedback amplifier, Negative feedback , Voltage series, Voltage shunt Current series Current shunt feedback
- 3. In the feedback process a part of output is sampled and fed back to the input. The fed back signal can be in phase with or out of phase with the original input signal. Definition of feedback: Feedback is defined as the process in which a part of output signal (voltage or current) is returned back to the input. The amplifier that operates on the principle of feedback is known as feedback amplifier.
- 4. 1. Positive feedback 2. Negative feedback. If the original input signal and the feedback signal are in phase, the feedback is called as positive feedback. However if these two signals are out of phase then the feedback is called as negative feedback.
- 5. The most important thing to understand from Fig. is that the output and input terminals of this amplifier are not connected to each other in any way. Therefore the amplifier of Fig. is an amplifier without any feedback, Gain without feedback.
- 6. Refer to Fig. Here the same amplifier with a gain A is being used along with a mixer network, sampling network and a feedback network. The voltage gain of the feedback amplifier is given by, Gain with feedback
- 7. The block diagram of an amplifier with a Negative Feedback Fig. Vf = β Vo Where Vf = Feedback signal (output of the feedback network) Vf Feedback factor β = Vo
- 8. Depending on the type of sampling and mixing networks, the feedback amplifiers are classified into four categories: Voltage series feedback Current series feedback Current shunt feedback Voltage shunt feedback
- 9. Therefore, voltage series feedback = voltage sampling + series mixing The voltage series feedback is present in the voltage amplifiers. A transistor amplifier which uses the voltage series feedback is the common collector or emitter follower amplifier: 1. A common collector (or emitter follower) amplifier using BJT. 2. A common drain (or source follower) amplifier using FET.
- 10. Therefore Current sampling + Series mixing. Current series feedback is present in the transconductance amplifiers.
- 11. This is a combination of current sampling and shunt mixing. The block diagram of a feedback amplifier with current shunt feedback is shown in Fig. Current sampling + Shunt mixing Current shunt feedback is present in the current amplifiers.
- 12. The block diagram of an amplifier with voltage shunt feedback amplifier is shown in Fig. Voltage Shunt Feedback = Voltage Sampling + Shunt Mixing. The voltage shunt feedback is present in the transresistance amplifier.
- 13. Advantages Negative feedback stabilizes the gain of the amplifier. Input resistance increases for certain feedback configurations. Output resistance decreases for certain feedback configurations. Operating point is stabilized. Disadvantages Reduction in gain. Reduction in input resistance in case of voltage shunt and current shunt type amplifiers. Increase in output resistance in case of current shunt and current series feedback amplifiers. Applications of negative feedback In a1most all the electronic amplifiers. In the regulated power supplies. In wideband amplifiers (amplifiers having a large bandwidth)