Oscilloscopes basics

Oscilloscopes basics

• 1.
  Basic of Oscilloscope By: SaumyaRanjan Behura 1
• 2.
  Scope2 A scope isa device that has measures the voltage across its input at a fixed rate. The scopes you will be using take a voltage measurement every ns s, which it stores in its memory (has room for 2500 measurements). It stores it with 8 bits of precision (1/28 =0.004). It then makes a graph of voltage versus time. The graph is refreshed whenever it receives a “trigger”. You set how which measurements it should display relative to the trigger time. The trigger is a condition you set on a signal fed into the signal input. When the signal satisfies the conditions, the display is refreshed. Often, you feed the same signal into the display input and the trigger input, but not always (you’ll see tomorrow an example of when you would want different inputs).
• 3.
  oscilloscope3 • oscilloscope refresher •learn wavestar
• 4.
  Scope Inputs4
• 5.
  Display5 1) ? 2) Goodtrigger received? 3) Trigger time 4) Delta_t trigger-center of display 5) Trigger level 6) Trigger level 7) Trigger slope 8) Trigger channel 9) lala 10) Time per tick, x axis 11) Volts per tick, y axis 12) Not sure 13) Ground level for each channel
• 6.
  Adjusting the Display6 t r i g g e r x a x i s y a x i s y a x i s
• 7.
  Practice Signal Source7 We’lluse a “signal generator” to make some voltages that vary with time, and then measure them using the oscilloscope, to prepare for tomorrow, when we’ll measure the signals from muons. “Coaxial cable” will take the “source” to the Scope.
• 8.
  Vocabulary8
• 9.
  Thank You 9
• 10.
  Thank You 9