Please read the most up-to-date instructions here: https://remake.ai/blog/voron-2-webcam-mount/. A webcam holder to mount common webcams on Voron 2.4 and 3D printers using 2020 extrusions. Specifically, this mount fits webcams that have a horizontal tube-like hole in the back. I have included the Autodesk Fusion 360 files.

• Print the parts. Use ABS, PETG or ASA that can withstand temperatures higher than PLA in your print chamber.
• Take an M3 screw long enough to span between the two arms; drive it through the left arm into the plastic hole of the right arm.
• Mount the camera by sliding a piece of 1.75mm filament through the mount arms and the webcam’s tube-like hole. The webcam’s tube-like hole diameter may be larger than the 1.75mm filament by a millimeter or two – and that’s ok as long as step 5 succeeds.
• Affix the two extrusion mounts to the 2020 extrusion using M3 screws and extrusion slot nuts of your preference (T-nuts, hammer nuts, roll-in-spring nuts, etc.)
• Tighten the long M3 screw gently. Don’t overtighten. The webcam should stay firmly in place – not droop down but be adjustable by hand without straining your fingers.
• Adjust the webcam holder arms angle for best (even) picture.

Happy 3D printing!