Scribd
Upload
102 views2 pages

7 Segment LED Counter Circuit

This 3 sentence summary provides the essential information about the 7 segment LED counter circuit: The circuit uses a 74LS90 TTL BCD counter IC and 74LS47 TTL seven segment display driver IC along with 7 resistors and a common anode 7 segment LED display to count TTL logic pulses and display the count on the LED display. The circuit can be expanded to add more digits by connecting the outputs of additional 74LS90 and 74LS47 ICs.

Uploaded by

Waseem Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
102 views2 pages

7 Segment LED Counter Circuit

This 3 sentence summary provides the essential information about the 7 segment LED counter circuit: The circuit uses a 74LS90 TTL BCD counter IC and 74LS47 TTL seven segment display driver IC along with 7 resistors and a common anode 7 segment LED display to count TTL logic pulses and display the count on the LED display. The circuit can be expanded to add more digits by connecting the outputs of additional 74LS90 and 74LS47 ICs.

Uploaded by

Waseem Ahmad
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd

7 Segment LED

Counter
Author

Views

Views Today

248,837

221

Rank

Comments
178

This simple counter can be used to count pulses, as the basis for a customer
counter (like you see at the doors of some stores), or for anything else that may
be counted. The circuit accepts any TTL compatible logic signal, and can be
expanded easily (see Notes).

Schematic

7 Segment Display Reference

Parts
Total
Qty.

Part
R1-R7 7
U1
1
U2

DISP1 1

Description
470 Ohm 1/4 Watt Resistor
74LS90 TTL BCD Counter IC
74LS47 TTL Seven Segment
Display Driver IC
Common Anode 7 Segment

Substitutions
7490,74HC90
7447,74HC47

MISC 1

LED Display
Board, Sockets For ICs, Wire

Notes
1. All pulses to be counted are to be TTL compatible. They should not exeed
5V and not fall below ground.
2. You can add more digits by building a second (or third, or fourth, etc...)
circuit and connecting the pin 11-6 junction of the 74LS90 and 74LS47 to
pin 14 of the 74LS90 in the other circuit. You can keep expanding this way
to as many digits as you want.

Related Circuits

You might also like