2010 Highway Capacity Manual
Joel Marcuson, PE
Jacobs Engineering
ICRT Ch 26 Chair, 2010 HCM
2010 HCM Format / Schedule
2010 HCM Format
2010 Highway Capacity Manual
TRB
HCQS
Publicatio
ns
Highway Capacity Volumes
1. Concepts
2. Uninterrupted Flow Facilities
3. Interrupted Flow Facilities
4. Applications Guide
Updates
Chapter 26 (Adopted): Interchange Ramp Terminals
Chapter X (Evaluation Copy): Local Urban Streets
NCHRP Report XXX: Analysis of Freeway Weaving
Sections
Copyright statement and legal notices
Webmaster
Contact
Research
5th Edition
NCHRP 3-92 Project Schedule
2007
2008
2010
2009
Gap-filling
research
complete
First draft
complete
Final draft
complete
Committee review between
meetings as individual draft
chapters are completed
Incorporation of New Research
NCHRP 33--60 (Interchange Ramp Terminals)
NCHRP 33--64 (HCM Applications Guide)
NCHRP 33--65 (Applying Modern Roundabouts in the United
States)
NCHRP 33--70 (Multi(Multi-Modal Arterial Level of Service)
NCHRP 33-75 (Analysis of Freeway Weaving)
NCHRP 33-79 (Predicting Travel Speeds for Urban Streets)
NCHRP 33--82 (Default Values for HCM)
NCHRP 33--85 (Guidelines for the Use of Alternative Traffic Analysis
Tools)
NCHRP 20
20--7 (Two(Two-lane Highways)
TCRP A
A--15A (Transit Capacity and Quality of Service 2nd Edition)
NCHRP 33--92
Signalized Intersection Methodology (New Delay Method and
Structure Changes reflecting Modern Actuated Control)
Gap Acceptance for Six Lane TwoTwo-Way Stop Controlled
Intersections
75 Mph Speed Flow Curve for Freeways
Roundabouts
2010 HCM - Roundabouts
Roundabouts: Need for improved HCM
procedure
Anchor to empirical U.S. performance
Ability to analyze multilane roundabouts
Able to be calibrated to local and/or
changing conditions
Roundabouts Key Findings
Key Operational Findings from NCHRP 572
U.S. roundabouts currently exhibit lower
capacities than observed in other countries
Capacity clearly sensitive to geometry in the
aggregate (number of lanes)
Secondary effects of geometry on capacity (e.g.,
lane width, diameter) masked by variations in
driver behavior
Lane--byLane
by-lane analysis of multilane roundabouts
needed
Roundabouts Procedure
Can be calibrated to locally measured critical headway
and follow
follow--up headway
Sensitive to turning movement assignment to individual
lanes
Sensitive to lane utilization
User has ability to assign traffic by lane to match existing
or projected conditions
Right--turn bypass lanes
Right
Type 1: Yielding
Type 2: Non
Non--yielding (acceleration or add lane)
PCE adjustment for heavy vehicles
PHF adjustment for peak 1515-minute flows
LOS definitions
Roundabouts Alternative Tools
2010 HCM will explicitly recognize that HCM
procedures are not the only way to analyze problems
Applicability of alternative tools to roundabouts
Geometric configurations not included in model
Oversaturated conditions requiring multiple
multiple--period
analysis
Interaction effects with other intersections
Overview of characteristics of applicable alternative tools
for roundabouts
Deterministic tools (e.g., SIDRA, RODEL)
Simulation (e.g., VISSIM)
Need for calibration
Roundabouts
Weaving
WEAVING -A New Way to
Measure Length
LS
LB
LL
WEAVING - No More:
Configuration Types (A,B, and C)
Unconstrained vs. Constrained Operation
New Variables Describing Configuration:
LCMIN = minimum number of lane changes for all
weaving vehicles to successfully complete
their desired weaving maneuvers.
NWL = number of lanes from which a weaving
maneuver can be made with no more than
one lane change.
Two-Sided Weaving Segments Considered as a
Special Case
(a) A Five-Lane Ramp-Weave Section
(b) A Four-Lane Major Weave Section
(No Lane Balance)
(c) A Four-Lane Major Weave Section
(With Lane Balance)
Examples
of
Configuration
Parameters
Determine the Capacity of the Weaving Section
Two Controls on Capacity
Capacity of the weaving section occurs at a point where the average
of all vehicles in the section reaches 43 pc/mi/ln.
Capacity of the weaving section occurs at a point where the weaving
vehicle demand flow rate reaches:
2,400 pc/h for cases in which NWL = 2
3,500 pc/h for cases in which NWL = 3
If cw < v, Level of service F exists.
If cw v, continue to estimate speeds, densities, and LOS.
v /N
S
Level of Service Criteria:
LOS
Density (pc/mi/ln)
Freeway Weaving Sections
Weaving Sections on CC-D
Roadways or Multilane
Highways
0 10
0 12
>10 20
> 12 24
> 20 28
> 24 32
> 28 35
> 32 36
> 35
> 36
v/c > 1.00
Urban Streets
Vision for Chapter 15
Scope
Urban street segment and facility evaluation
Auto, bike, and pedestrian modes
Recognize that sophisticated software tools are
available and better suited to some applications
Attributes
Useful to planner, designer, traffic engineer
Pedestrian and Bike Methodology
Developed by NCHRP Project 33--70
Automobile Methodology
Analysis Unit
Segment
Includes all movements at signals
Can include movements at access points
Supports
facility analysis
Active Access Point
Subject Intersection
Upstream Intersection
- Subject segment
Methodology
Actuated Phase Duration Prediction
Controller operation inputs
Simultaneous gap
gap--out
Dallas phasing
Controller phase inputs
Passage time
Minimum green
Recall
Dual entry
HCM Chapter 16 -Appendix B
Methodology
Coordinated-Actuated Operation
CoordinatedController inputs
Force mode
Splits used to estimate force off & yield
F.O. F.O.
Y.P.
points
Offset & offset reference point
Offset
F.O. F.O.
Y.P.
Methodology
Arrival Flow Profile Prediction
Computes adjusted volume
Balance flows between junctions
Check and honor capacity constraints to
entry flows
Computes OO-D matrix
Distribution of each entry mvmt. to all four
exit movements
Based on turn
turn--mvmt. estimation method in
Chapter 10
Upstream Intersection
Subject Intersection
Methodology
Spillback Prediction
Sustained queue backs up for length of
segment
Model prediction
Identify time when spillback occurs
Uses
Indicates green needs to be better allocated
Indicates simulation should be considered
Performance Measures
Average travel speed
Control delay
Stop rate
Interchange Ramp Terminals
Highway Capacity Manual Chapter
Interchange RampRamp-Terminals
Joel Marcuson, PE
Jacobs Engineering
ICRT Ch 26 Chair, 2010 HCM
Background - Purpose 360:
New Interchange Chapter:
Develop Accepted Analytic Procedure
Single and Dual Intersection Interchanges
SPUIs, Diamonds, Par
Par--Clos
Chapter 26 Major Changes:
Identify a Process to Analyze Interchanges
Level of Service Changed to Reflect Experience
Single or MultiMulti-Intersection Device
More Complicated than Intersection
Analysis
More Delay than Typical Intersections
Origin--Destinations Important
Origin
Operational Impacts of Intersection Spacing
Lane Utilization (Particularly LeftLeft-Turns)
Demand Starvation (Unused Green)
Interchange Selection Process
Chapter 26 Why Needed?
No Guidance Today
Pandoras Box of Procedures Used
HCM, Intersections
Simulation
Others
No Uniform Method to Check Against
Results
Good?
Bad?
Reliable?
Cost $30M & Up, Based on Unfounded Analysis
Types of
Interchanges
Conventional, D >800 ft
Compressed, D =400-800 ft
Tight Urban, D <400 ft
Diamond with continuous
frontage roads
Diamond with U-turn
lanes and service roads
Split diamond interchange
(cross roads, one- or two- way)
Partial (half) diamond
interchange
Three-level diamond
interchange
Parclo A, 2 Quadrants
Parclo A, 4 Quadrants
Parclo B, 2 Quadrants
Parclo B, 4 Quadrants
Parclo AB, 2 Quadrants
Parclo AB, 4 Quadrants
Types of
Interchanges
(contd)
Unique Operational Characteristics
of Interchanges
Unique Operational Characteristics
of Interchanges (contd)
Queue presence in the internal link
Distance between the two intersections.
Demand starvation potential.
Demand Starvation
Level of Service Framework
LOS
A
B
C
D
E
F
Delay
<15
15--30
15
30--55
30
55--85
55
85--120
85
V/C>1.0, Rq>1.0
Performance Measures and LOS
Average Queue Storage Ratio for each lane
group
V/C for each lane group
Average Control Delay for each lane group,
and for each OriginOrigin-Destination
LOS determination based on OriginOriginDestinations
Next Steps
HCS+ Now Incorporates Interchanges
NCHRP 33--60 Extension
- Collecting Additional Field Data
- Incorporate Nearby Intersections
- Include 33-65 Roundabouts
HCM 2010 to incorporate New Interchange
Method
HCS+Interchanges
Software Released
HCS+ 5.3
McTrans
