Scribd
Upload
308 views3 pages

Purlin Design

The document provides design calculations for purlin sections used in a roof with a span of 11.1 meters and truss spacing of 6.095 meters. It calculates the required bending moment of 0.32 MNm based on a wind load of 0 kN/m^2. The required section modulus is determined to be 1466.03 mm^3. Based on this, an ISA 80x50x10 angle section is selected, which provides a section modulus of 10.9 cm^3, satisfying the required section modulus.

Uploaded by

KNB KN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
308 views3 pages

Purlin Design

The document provides design calculations for purlin sections used in a roof with a span of 11.1 meters and truss spacing of 6.095 meters. It calculates the required bending moment of 0.32 MNm based on a wind load of 0 kN/m^2. The required section modulus is determined to be 1466.03 mm^3. Based on this, an ISA 80x50x10 angle section is selected, which provides a section modulus of 10.9 cm^3, satisfying the required section modulus.

Uploaded by

KNB KN
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

DESIGN OF PURLIN ( I SECTIONS )

LENGTH OF TRUSS = 11.1 m


SPACING OF TRUSS = 6.095 m 6095 mm
SPACING OF PURLINS = 1.1 m
2
INTENSITY OF WIND PRESSURE = 0 KN/m
2
WEIGHT OF COVERING SHEETS = 0 N/m
2
YIELD STRESS OF STEEL = 250 N/mm (MPA)
SLOPE OF ROOF 30 deg
DEAD LOAD OF PURLIN (assume) = 100 N/m
LIVE LOAD 0 N/m
Weight of covering sheets = 0 N/m
TOTAL DEAD LOAD = 100 N/m

load parallel to roof (H') = 50 N/m


load normal to roof = 86.60 N/m
wind load = 0 N/m

total load (P') = 86.60 N/m

6
maximum Bending Moment M uu = 321719.994 N/mm 0.32 E N/mm

2 2
σbc = 165 N/mm 219.45 N/mm
Increase the permissible compresssive
stress σbc by 33% to account wind load

SECTION MODULUS REQUIRED Z = Muu


( 1.33 X σbc )
3 3
= 1466.03 mm 1.47 cm

DEPTH OF ANGLE PURLIN (L/45) = 135.44 mm 80 mm


WIDTH OF ANGLE PURLIN (L/60) = 101.583333 mm 50 mm

PROVIDE ANGLE SECTION = ISA80x50x10

3 3
Zxx = 10.9 cm 10900 mm

σbc 1.47 < 10.9 HENCE OK

DEFLECTION CALCULATION
*PI()/180
(H')

= (P'xL)/10

You might also like