Scribd
Upload
1K views4 pages

M2540dw - Fuser Replacement

The document provides step-by-step instructions for detaching and reattaching the fuser unit in a printer. It details removing covers, disconnecting connectors, and removing screws to access the fuser unit. Four screws must be removed to pull out the fuser unit. Care is advised when handling the hot components.

Uploaded by

Adam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
1K views4 pages

M2540dw - Fuser Replacement

The document provides step-by-step instructions for detaching and reattaching the fuser unit in a printer. It details removing covers, disconnecting connectors, and removing screws to access the fuser unit. Four screws must be removed to pull out the fuser unit. Care is advised when handling the hot components.

Uploaded by

Adam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

[CONFIDENTIAL]

2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA

(5) Fuser section


(5-1)Detaching and reattaching the fuser unit
Procedures
1. Slightly pull out the cassette b
2. Open the rear cover (a). b
3. Open the cassette cover (c) and
release the hook (d) of the left rear
cover (b) in the direction of the arrow.
e
4. Twist the rear left cover (b) to release e
the hook (e) and detach it. d
d
Attention:
The direction of hook (d) or (e) is reverse. Pay
a
attention to the damage when detaching. a

c d
c d

Figure 4-24

5. Open the rear cover (a) to align it to the


position of the shaft (b) and detach it
from the fulcrum (c) in the direction of
the arrow.
c

Figure 4-25

4-17
[CONFIDENTIAL]
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA

6. After twisting the DIMM cover(a),


remove it while sliding it

1
2

Figure 4-26

7. Twist the right rear cover(a) and detach


it while sliding it.

1
2

Figure 4-27

4-18
[CONFIDENTIAL]
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA

8. Remove two screws (a)(M3x8P tight)


and detach the fuser wire cover (b).

Figure 4-28

9. Disconnect the connector(a) from the


low voltage power source PWB.
10. Disconnect the connector (b) from the
main/ engine PWB.

Figure 4-29

4-19
[CONFIDENTIAL]
2S0/2S1/2S2/2S3/2S4/2S5/2SG/2SH/3RA

11. Remove four screws (a) (M3×8S tight).

Figure 4-30

12. Pull out the fuser unit (a) while holding


the both ends of it.
13. Check or replace the fuser unit (a), and
then reattach the parts which are
detached in the original position.

a
Attention:
When detaching and reattaching, pay atten-
tion not to burn by touching the hot section.

Figure 4-31

4-20

You might also like