AVD-07UX2SAL(H),
UX L AVD-24UX2SBL(H),
UX L
AVD-09UX2SAL(H),
UX L AVD-27UX2SCL(H),
UX L
CEILING AVD-12UX2SAL(H),
UX L AVD-30UX2SCL(H),
UX L
DUCTED AVD-14UX2SAL(H),
UX L AVD-38UX2SCL(H),
UX L
TYPE AVD-17UX2SBL(H),
UX L AVD-48UX2SDL(H),
UX L
AVD-18UX2SBL(H),
UX L AVD-54UX2SDL(H),
UX L
AVD-22UX2SBL(H)
UX L
P00540Q
ORIGINAL INSTRUCTIONS
Hisense
Hisense
Hisense
IMPORTANT NOTICE
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.
Hisense's
Hisense's
3
3
4
4
4
4
4
Section2 Installation & Maintenance Manual
5
5
6
7
7
10
10
10
11
12
12
12
13
13
14
14
14
15
l The appliance is not to be used by children or
person with reduced physical, sensory or mental
capabilities,or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
l Children should be supervised that they do not
play with the appliance.
l The appliance should not be installed in the
laundry.
3
10 Btu/h
07 09 12 14 17 18 22 24 27 30
CEILING
DUCTED
38 48 54
TYPE
Regarding the instructions of Wired Remote
Control Switch or Wireless Remote Control
Switch,read the operation manual attached
to the control switch.
6. Automatic Control
3
7. Troubleshooting
4
R410A
5
2.5
6
7
07 14
17 24
27 38
48 54
8
Model Static Pressure(Pa)
AVD-07 14UX2SAL
UX L, AVD-17 L
24UX2SBL
UX 30
AVD-27 38UX2SC
UX L, AVD-48 54UX2SDL
UX L 60
AVD-07 H,
14UX2SAL
UX AVD-17 H
24UX2SBL
UX 50(*)/80
AVD-27 38UX2SCL
UX H, AVD-48 54UX2SDL
UX H 120(*)/90
* Before Shipment
9
10A
07 14
17 18
22 30
38 54
Flaring Dimension
Perform the flaring work as shown below.
+0
Diameter A -0.4
R410A R407C
6.35 9.1 9.0
9.53 13.2 13.0
12.7 16.6 16.2
15.88 19.7 19.4
19.05 (*) 23.3
+0
A -0.4
(*)It is impossible to perform the flaring work with
1/2H material. In this case, use an accessory
pipe(with a flare).
An excess or a shortage of refrigerant is the
main cause of trouble to the units.
Charge the correct refrigerant quantity.
07 14
17 18
22 24
27 38
48 54
10
07-14 10 3 Btu/h
17-54 10 3 Btu/h
11
12
17~24
27~38
07~14
48~54
Cord Clamp
220V~ 60Hz
AVD-07 14UX2SAH
UX
AVD-17 24UX2SBH
UX
AVD-27 38UX2SCH
UX
AVD-48 54UX2SDH
UX
13
Maximum
EN60 335-1 EN60 335-1
Current 1 1
07 54
07 09 1.1A
12 14 1.5A
17 22 1.6A
m2
2.5m 0.75mm2
24 1.9A
27 38 3.0A
48 54 4.2A
The wire sizes marked with *1 in the above table are selected
at the maximum current of the unit according to the European
Standard, EN60 335-1.Use the wires which are not lighter than
the ordinary polyvinyl chloride sheathed flexible cord
(code designation H05VV-F).
3
Use an ELB (Electric Leakage Breaker).If not EN60 335-1
used ,it will cause an electric shock or a fire.
Run through the cables using conduit tube, 6 2.5
and Completely seal the end of conduit tube 6 10 2.5
with sealing materials. 10 16 2.5
16 25 4
25 32 6
32 40 10
40 63 16
63 ※1
14
Ex.) Set at No.5 Cycle
Setting Set by inserting DSW5
Position Slotted screwdriver
into the groove
Set All Pins OFF
Before shipment. DSW5 and RSW2 are set to "0".
RSW2
Max.64 cycles are available to set when all the equipment
to be connected are corresponding to Hi-NET.
Max.16 cycles when the units corresponding/
non-corresponding to Hi-NET are combined. Set at "5"
Ex.) Set at No.16 Unit
Setting Set by inserting DSW6
Position Slotted screwdriver
into the groove
Set No.1 Pin ON
Before shipment. DSW6 and RSW1 are set to "0".
RSW1
Max.64 units are available to set when all the equipment
to be connected are corresponding to Hi-NET.
Max.16 units when the units corresponding/
non-corresponding to Hi-NET are combined. Set at "6"
Capacity 07 09 12 14 17 18 22
Capacity 24 27 30 38 48 54
15
1018383
Qingdao Hisense Hitachi Air-conditioning Systems Co., Ltd.
Add: 218, Qianwangang Road, Economic & Technical Development Zone, Qingdao, P.R. China
http://www.hisense-vrf.com E-mail:
[email protected] P00540Q, 2018.03 V01
