Scribd
Upload
53 views2 pages

As Indicated in SBC 304

Chapter 25 of SBC 304-CR-18 outlines the reinforcement details for deformed bars and wires in tension, specifying the development length and splice requirements. The development length must be the greater of a calculated value or 300 mm, while lap splice lengths are defined in accordance with specific tables. Additionally, standard hooks and seismic hooks for deformed bars must meet the criteria set in the relevant table.

Uploaded by

MahMoudAbdEl-Kader
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
53 views2 pages

As Indicated in SBC 304

Chapter 25 of SBC 304-CR-18 outlines the reinforcement details for deformed bars and wires in tension, specifying the development length and splice requirements. The development length must be the greater of a calculated value or 300 mm, while lap splice lengths are defined in accordance with specific tables. Additionally, standard hooks and seismic hooks for deformed bars must meet the criteria set in the relevant table.

Uploaded by

MahMoudAbdEl-Kader
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

As indicated in SBC 304-CR-18

CHAPTER 25—REINFORCEMENT DETAILS

25.4—Development of reinforcement
25.4.2 Development of deformed bars and
deformed wires in tension
[Link] Development length 𝑙𝑙𝑑𝑑 for deformed bars
and deformed wires in tension shall be the greater
of (a) and (b):
(a) Length calculated in accordance with
[Link] or [Link] using the applicable
modification factors of [Link]
(b) 300 mm
[Link] For deformed bars or deformed wires, 𝑙𝑙𝑑𝑑
shall be calculated in accordance with Table
[Link].
25.5—Splices
25.5.2 Lap splice lengths of deformed bars and
deformed wires in tension
[Link] Tension lap splice length 𝑙𝑙 for
deformed bars and deformed wires in tension
shall be in accordance with Table [Link], where
𝑙𝑙 𝑑𝑑 shall be in accordance with [Link](a).

25.3—Standard hooks, seismic hooks,


crossties, and minimum inside bend
diameters
25.3.1 Standard hooks for the development of
deformed bars in tension shall conform to Table
25.3.1.

You might also like