DHIRAJLAL GANDHI COLLEGE OF TECHNOLOGY, SALEM

Department of Electronics and Communication Engineering

Year/Sem/ Sec I/II/B Time 3 hours

Max.Marks 100 Date 20.05.2025

Model Exam
24TEC202- CIRCUIT ANALYSIS
PART-A (10X2=20) BL COs
In a circuit consisting of two 50 Ω resistors connected in series and third resistor R
is connected across the series resistors. The equivalent resistance is found to be
60Ω. calculate the resistance value of R.
L1 1
1
Req = (100*R)/(100+R) = 60

Req = 150 Ω
Find the value of the current I, for the circuit shown below.

L1 1
2

V −5 V
+ =1
5 15
V = 7.5 V
I =7.5/15 = 0.5 A
If all the three Delta connected impedance are identical and equal to Z, what are
L1 2
3 the Star equivalent impedance? Zeq = Z/3

Draw the dual of the given network

Answer:
L1 2
4

A voltage of 240 sin 377t is applied to a 6Ω resistor. Find the instantaneous power
and average power.
V m Sinwt 240 sin377 t
L1 3
5 Instantaneous current = = ¿ ¿ = 40sin377t
R 6
P = Vm ImSin^2 wt =240*40*Sin^2 377t = 9600Sin^2 377t
Average Power = P = Vm Im /2 = 4800 W
 Show the waveform representation of applied voltage across inductor, and the
resulting current.

L1
6 3

Define resonance. What is the condition for an RLC series circuit?

L1
7 ωL = ω c 4

An RC series circuit has R =20Ω , C=400 µF. What is its time constant?
L1
8 Time constant = 8 mS 4

Two 2H inductance coils are connected in series aiding and are also magnetically
coupled to each other, the coefficient of coupling being 0.1. find the total L1
9 5
inductance of the combination.
L = L1 + L2 +2M = 4.2 H
List the properties of incidence matrix.
 The sum of values of [A]ij of any column is equal to zero.
L1
10  For a closed loop system, the determinant of [A]ij is always zero. 5
 The rank of the complete incidence matrix [A]ij is n-1 where n=number of
nodes in the graph.
PART-B (5X16=80)
11 (a) (i) What is the voltage across A and B in the circuit

L3 1

L3 1
(ii) Calculate the equivalent resistance between the terminals A and B of the
circuit shown below.

Req = 0.618 Ω

(OR)

Use Nodal voltage method and find the power dissipated in 10Ω
resistor.

L3 2
11 (b)

12 (a) Determine the load resistance to receive maximum power from the source; L3 2
also find the maximum power delivered to the load in the circuit
 (OR)
12 (b) Find the voltage across the 2 Ω resistor by using the super position theorem L3 2
 In the network, shown in figure the source V 1 results in a voltage V0 across the L3 3
13 (a) (2-2j) Ω impedance. Find the source V1 which corresponds to V0 =5 L00
 (OR)
13 (b)(i) A coil of resistance 10Ω and inductance 0.1 H is connected in series with L2 3
150µf capacitor across 200V, 50Hz.
Calculate
(i) inductive reactance and capacitive reactance
(ii) Impedance
(iii) current
(iv) power factor
(V) the voltage across the coil and capacitor.

(AND)

A series RLC circuit has R=100Ω, L=0.7H and C=70μF. The applied voltage is
100V. Find (i) resonant frequency (ii) quality factor (iii) upper half power
frequency (iv) lower half power frequency (v) bamdwidth (vi) volatge across
inductance at resonance.
14 (a) L3 4
 (OR)

14 (b) (i) Show that ω1 ω2 = ω2r for a series resonant circuit.

L2 4

(ii) Find the value of L at which the circuit resonates at a frequency of 1000 rad / L2 4
sec in the circuit
 In the coupled circuit, find the voltage across the 5 Ω resistors. L3 5
15 (a)(i)
 For the circuit shown below find the ratio of the output voltage to the source
voltage.

(ii)

(OR)
15 (b) Draw its topological graph and write its incidence matrix, tie set matrix, link
current transformation equation and branch currents and also determine the
number of possible tree.

L3 5

Course Coordinator Module Coordinator HOD/ Programme Coordinator