Scribd
Upload
358 views1 page

Mid 128 Pid 175 Engine Oil Temp Codes

The document outlines troubleshooting procedures for MID 128 PID 175 related to engine oil temperature and pressure sensors. It details fault codes, their conditions, possible causes, EECU reactions, and noticeable symptoms for high temperature, short circuits, and open circuits. Each fault code triggers specific warning lamps and may affect engine performance based on the severity of the issue.

Uploaded by

Carlos Riffo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
358 views1 page

Mid 128 Pid 175 Engine Oil Temp Codes

The document outlines troubleshooting procedures for MID 128 PID 175 related to engine oil temperature and pressure sensors. It details fault codes, their conditions, possible causes, EECU reactions, and noticeable symptoms for high temperature, short circuits, and open circuits. Each fault code triggers specific warning lamps and may affect engine performance based on the severity of the issue.

Uploaded by

Carlos Riffo
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd

Group 28 Troubleshooting

MID 128 PID 175 Engine Oil Temperature


In addition to the oil temperature, the sensor also measures the oil pressure.

Fault Codes
FMI 0 FMI 4
Temperature too high. Short circuit to ground.

Conditions for fault code: Conditions for fault code:


 
• The oil temperature exceeds 130 C (266 F). • The voltage on EA1 is under 0.08 V.

Possible cause: Possible cause:

• Poor cooling capacity. • Short circuit to ground, signal wire.

• Fault in sensor. • Fault in sensor.

Reaction from the EECU: Reaction from the EECU:

• Fault code is set. • Fault code is set.

• Red lamp is requested. • Yellow lamp is requested.

Noticeable external symptom: • The EECU stops sending PID 175.

• Red lamp lights up. Noticeable external symptom:


 
• Power reduction in the first stage (at 130 C (266 F) • Yellow lamp lights up.
and shutdown in 2nd stage (if engine protection is
chosen in the data set). • The oil temperature gauge shows 0.

FMI 3
Short circuit to voltage or open circuit.

Conditions for fault code:

• The voltage on EA1 exceeds 4.95 V.

Possible cause:

• Short circuit to voltage, signal wire.

• Short circuit to voltage, ground wire.

• Break, signal wire.

• Break, ground wire.

• Fault in sensor.

Reaction from the EECU:

• Fault code is set.

• Yellow lamp is requested.

• The EECU stops sending PID 175.

Noticeable external symptom:

• Yellow lamp lights up.

• The oil temperature gauge shows 0.

139

You might also like