EC-108 - BASIC ELECTRONICS LAB
Course Title: Basic Electronics lab Course Code : EC-108
Semester: I Semester Course Group : Practical
Teaching Scheme in 1:0:2 Credits : 1.25
Periods(L:T:P):
Methodology : Lecture+ Practical Total Contact Periods : 45 Periods
CIE : 60 Marks SEE : 40 Marks
Pre requisites
This course requires the basic knowledge of electrical engineering and semiconductor devices
Course Outcomes
On completion of the course, the student should be able to:
CO1 Identify and test the various electronic components
CO2 Plot the characteristics of semiconductor devices
CO3 Analyze the different packages and types of semiconductor devices and
components.
Course Content and Blue Print of Marks for SEE
Unit Unit Name Periods Questions to be set for SEE
No R U A
Identify the various electronic
1 9
components and test them.
2 Plot the characteristics of
30
semiconductor devices
3 Analyze the different packages
and types of semiconductor 6
devices and components.
Total 45
Suggested E-learning references
1. http://nptel.ac.in
2. https://www.youtube.com
Suggested Learning Outcomes
Upon completion of the course, the student shall be able to
1. Identify and test different types of active and passive components.
2. Study and observe the front panel controls of CRO.
3. Study and observe the front panel controls of RF signal generator.
4. Test the given transformer and find the turns ratio.
5. Measure the value of colour coded resistors and verify theoretically.
6. Determine the equivalent resistance in series connection and verify theoretically.
7. Determine the equivalent resistance in parallel connection and verify theoretically.
8. Connect a series parallel circuit, measure the voltage and current, verify theoretically.
9. Identify the terminals of PN diode, Zener diode and BJT with a multimeter.
10. Test the given p-n diode and BJT.
11. Obtain the forward bias characteristics of PN diode and calculate its forward resistance from
graph.
12. Obtain the reverse bias characteristics of PN diode and calculate its reverse resistance from
graph.
13. Plot the characteristics of Zener diode.
14. Plot the input characteristics of BJT in CE configuration.
15. Plot the output characteristics of BJT in CE configuration.
16. Draw the output waveforms of HWR without filter.
17. Draw the output waveforms of FWR without filter.
CO-PO Mapping Matrix
and
Basic and Discipline
Design/Development of
and
Society,
Tools,
Engineering Practices
Project Management
Specific Knowledge
Lifelong Learning
Problem Analysis
Experimentation
Sustainability
Environment
Engineering
Solutions
Linked PO
Testing
for
CO PO1 PO2 PO3 PO4 PO5 PO6 PO 7
CO1 3 2 1 1 3 1,3,4,6,7
CO2 3 2 1 3 3 1,3,4,6,7
CO3 3 2 1 1 3 1,3,4,6,7
QUESTION PAPER PATTERN FOR SEMESTER END EXAM
Sl.No Description Level No of Marks for Choice Total
Questions each Marks
question
01 Part-A Remembering(R) 4 4 Nil 16 Marks
and
Understanding(U)
02 Part-B Application(A) 2 24 1 24 Marks
Total Marks 40 Marks
