ITS ENGINEERING COLLEGE
Topic :Role of Reactive Power in Power System
Presented By: Manish Kumar Presentation Taken by:
Branch: EEE Upendra Kumar Aggarwal
Roll No. 1622221011
Overview Of Presentation
Introduction
Importance Of Reactive Power
Necessary To Control Of Voltage &
Reactive Power
Basic Concept Of Reactive Power
How Voltages Controlled by Reactive
Power
Reactive Power Limitations
INTRODUCTION
Importance of reactive power is
increasing with growing demand
for electrical power by many
domestic and industrial utilities, in
power system network. Stability
and reliability of electrical power
system depends on reactive
power management.
IMPORTANCE OF REACTIVE POWER
Reactive power provides the
important function of regulating
voltage. Reactive power is
essential to move
active power through the
transmission and
distribution system to the customer
.Reactive power is required to
maintain the voltage to deliver
active power (watts) through
transmission lines.
Control Of Voltage and Reactive Power
Voltage control and reactive power management
are two aspects of a single activity that both
supports reliability and facilitates commercial
transactions across transmission networks.
First, both customer and power system equipment
are designed to operate within a range of voltages,
usually within±5% of the nominal voltage. At low
voltages, many types of equipment perform poorly,
light bulbs [Link] less illumination,
induction motors can overheat and be damaged,
and some electronic equipment will not operate at.
High voltages can damage equipment and shorten
their
First, the transmission system itself is a nonlinear consumer of
reactive power, depending on system loading. At very light
loading the system generates reactive power that must be
absorbed, while at heavy loading the system consumes a large
amount of reactive power that must be replaced. The system’s
reactive power requirements also depend on the generation
and transmission configuration.
Loads can also be both real and reactive. The reactive portion
of the load could be served from the transmission system.
Reactive loads incur more voltage drop and reactive losses in
the transmission system than do similar size (MVA) real loads.
Basic Concept Of Reactive Power
Active power is the energy supplied to run a motor, heat
a home, or illuminate an electric light bulb. Reactive
power provides the important function of regulating
voltage. If voltage on the system is not high enough,
active power cannot be supplied. Reactive power is
used to provide the voltage levels necessary for active
power to do useful work.
Must raise the voltage higher to push the power through
the inductance of the lines III. Unless capacitance is
introduced to offset inductance
How Voltages Controlled by Reactive Power
Voltages are controlled by providing
sufficient reactive power control margin
to supply needs through:
1. Shunt capacitor and reactor
compensations
2. Dynamic compensation
3. Proper voltage schedule of
generation.
Voltages are controlled by predicting
and correcting reactive power demand
from loads
Reactive Power Limitations
Reactive power does not travel very far.
Usually necessary to produce it close to the location
where it is needed .A supplier/source close to the
location of the need is in a much better position to
provide reactive power versus one that is located far
from the location of the need .
Reactive power supplies are closely tied to the ability
to deliver real or active power.
