of Page(s): Roll No
) SEMESTER [Link]. (BCE)
END SEM. EXAMINATION, Nov.-Dec. 2024
Course Code: ECECC-304
Course Title: Microelectronics Circuits and Applications
Tine: 03:00 Hrs.
Max. Marks: 50
Note: Attempt all the five questions. All questions carry equal marks. Missin~j
data/information if any will be suitably assumed and mentioned in the answer.
Q. Question
No. Marks Co
Ql Attempt any 2 parts of the following
~ i) For the Differential Amplifier and ACM.
‘5.0~
‘~oL
I (a) (3+2)
CO I
o~QO)(
. Fig. 1(a)
ii) Define CMRR for differential amplifier and calculate the same for the circuit shown in
Fig. 1(a).
For the circuit shown in Fig. 1(b): i) Draw small signal equivalent circuit. ii) Find overall
gain.
i (b)
g~ k~
E~ct,. (1+4)
Co i
~$
— Fig. 1(b)
i) A series-series feedback circuit representable by Fig. l(c) and using ideal trans
conductance amplifier operates with V~ = I 00mV Vr ocmv mid T~ ~‘i OrnA ~Xfl.t4 .n..
corresponding values of A and f3. Include the unit in each answer
(c) (3+2) C03
-— ---~-—----—-—- ~~Fig:1(~) ~
ii) Find R~f in tenns of R~, A and 13 for series-series topology
2 I Attempt any 2 parts of the following ,, I______
‘ For the amplifier shown in Fig. 2(a), is biased to operate at Ip = lmA, gm =1mAJV, Ro
1 OkO, Rs = 6k12. Neglecting ro, find the values of Cs that places fL at 100Hz.
:
2(a)
J R~=loK
(5) C02
Fig._3(c)
Attempt any 2 parts of the following
4 a~ Draw the circuit of MOSFET based casoode curreni ~irror and derive the expressions lb (5) C04
/ output resistance. Also list ideal characteristics of a irrent mirror.
Fig. 2(a) i) Draw the circuit of class B push-pull a iplifier and derive its relation of —
For the circuit shown in Fig. 2(b) draw small signal high frequency equivalent circuit and 4rbN
‘ “
conversion (overall) efficiency.
ii) Class B push-pull amplifier with Vcc = 25V dri s a 8Q load. Determine the maximum (2+3) 004
find higher cut of frequency (Th) by assuming the dominant pole approximation is valid.
input power, output power, efficiency and power dis ipated by each transistor. —
Design a MOSFET based current mirror to obtain at output current of 5OgA (Fg. 4(c)). ‘6’po
= 1.8V, I,,~= 5OgA, find R, ifM, and M2 are ma- hed withL 0.5gm, W 5gm, Vt
[Link], K, 25OgAJV2.
=
2(b) (5) v~’D
c V co2
w 4(c) (5) 004
!~
Fig.2(b)
For the common emitter amplifier shown in Fig. 2(o), find lower cut of frequency (fj.
Fig._4(c)
~l
Attempt any 2 parts of the following 1_ —
2(c) el— (5) 002
5’&
~ State the Earithausen
expressions Criteria.
for condition Draw MOSFET
of sustained oscillationban I Wein-bridge
am frequency oscillator and derivq its
cf oscillation. (5) ~
c~ 51b) Draw and explain working of first order low pass arc high pass active filters using OpAinp
I (5) 005
rs 5’c)
‘
‘
having 10 kHz cut-off frequency and gaiff by/V.
Draw the circuit of two-integrator loop topology bas d KEN filter and derive its expressi~ns
for high-pass, band-pass and low-pass filters. I (5) 005
Fig. 2(c)
~ Attempt any 2 parts of the following
Draw the feedback amplifier in signal flow graph form) block diagram and find gain with
3(a) feedback (Ar), assuming that negative feedback is applied. Draw the series-shunt topology (5) 003
and find its Rjrand Rorin terms ofA and ~. — -
For the circuit shown in Fig. 3(b), with following parameters: Re = 4k≤2, RF 40kfl, Rs
lOko, ~, = [Link], transistor current gain (hr0~ = 50, find Ar, Rir, and Roe.
4” Vcc
g~
V0
3(b) (5) 063
g3
~4
— Fig. 3(b) ——
3(o) For the series-shunt amplifier shown in Fig. 3(c), find Ar, The, and Roe. 15) C03
